by Michael Decipha Ponthieux
Posted: 2013-08-18
Last Updated: 2017-10-11
| PID | Parameter | Manual Value | Automatic Value | Comment | |
| TRLOAD | Transmission Type | 0 | > 3 | This scalar determines the type of transmission present, 0=forced neutral, 1=no clutch sw, 2=1 clutch sw, 3=both switches, 4=auto w/ drive sw, 5=auto w/ pressure sw, 6=auto w/ MLPS | |
| TSTRAT | Trans Strategy | 0 or 1 | 2+ | Determines the trans strategy to use, 0=none, 1= shift light, 2=a4ld, 3=axod, 4=e4od, 5=a4ld-e, 6=fax4, 7=4r70w/aode, 8=4eat, 9=cd4e | |
| THE FOLLOWING APPLIES TO 98+ ECU's | |||||
| OSS_HP | OSS Present | 0 | 1 | may or may not be present on manual transmission | |
| OSS_INT_SW | OSS Enable | 0 | 1 | it is not absolutely required to alter this value | |
| OSS_TEETH | OSS Count | 12 | 6+ | update the oss count with the # of teeth on your oss sensor (if your trans has one) | |
| AUTO_TRNS_SW | Auto Trans Present | 0 | 1 | ||
| TRS_TYPE | Shift Sensor Type | 0 | 1 | ||
| OSS_ERR_SW | OSS Error Enable | 0 | 1 | not absolutely required to change this value | |
| OS_NOISE_SW | OSS Noise Enable | 0 | 1 | not absolutely required to change this value | |
| OTEMP_ERR_SW | Overtemp Error Enable | 0 | 1 | not absolutely required to change this value | |
| SFT_ERR_SW | Shift Error Enable | 0 | 1 | not absolutely required to change this value | |
| SW_1743_TCIL | TCIL 1743 Enable | 0 | 1 | not absolutely required to change this value | |
| TCC_FNERR_SW | TCC Error Enable | 0 | 1 | not absolutely required to change this value | |
| TCC_ERR_SW | TCC Error Enable | 0 | 1 | not absolutely required to change this value | |
| TRANS_SLP_SW | Trans Slip Error Enable | 0 | 1 | not absolutely required to change this value | |
| TRS_ERR_SW | TRS Error Enable | 0 | 1 | not absolutely required to change this value | |
| VSS_ERR_SW | VSS Error Enable | 0 | 1 | not absolutely required to change this value | |
| VS_NOISE_SW | VS Noise Enable | 0 | 1 | not absolutely required to change this value | |
| TCC_ON_SW | TCC On Enable | 0 | 1 | not absolutely required to change this value | |
| TCC_CK_MILSW | TCC Check MIL Enable | 0 | 1 | not absolutely required to change this value | |
| MLPS_KOEO_EN | MLPS KOEO Test Enable | 0 | 1 | not absolutely required to change this value | |
| FNSSCTL2 | Shift Solenoid Config | TABLE | TABLE | should not change this table unless the a different automatic transmission strategy is used | |
| The following applies to 99+ | |||||
| BIHP | Brake SW Present | 0 | 1 | this will unlock the tcc when brake is pressed | |